Call (253) 366-2904
Royal Flush Plumbing logo

Rough-In Plumbing in Tacoma for Remodels, Additions and ADUs

The supply, drain and vent piping that goes in before the walls close, for bathroom remodels, additions, ADUs and new homes across Tacoma and Pierce County, pressure-tested and ready for inspection.

The Plumbing That Decides How the Finished Room Works

Rough-in is everything that goes in before the walls and floors close: the water supply lines, the drain, waste and vent piping, and the stub-outs every fixture will connect to. Royal Flush Plumbing roughs in bathrooms, kitchens, additions and backyard cottages for homeowners across Tacoma and Pierce County, tests the work and has it ready for the inspector.

This September, in Northeast Tacoma, a homeowner was turning one dated bathroom layout into two working bathrooms. Charles walked the house first and planned it with them: the toilet would move about six feet, with a sink where it had been, and the shower would shift about three feet. Aiden then cut out the old shower, sink and toilet and roughed in a new toilet, sink and shower with both a showerhead and a handheld in the first bathroom, tied into the existing 3-inch stack. The second bathroom got the same three fixtures, which meant running 20 feet of 3-inch ABS down the lower bathroom wall to the main drain in the crawl space. Everything was tested for leaks before the walls went back.

Request Service
Open bathroom floor framing with a black ABS drain line, a toilet flange set in plywood and a wall frame with a purple support bracket for the sink
Aiden’s rough-in for a relocated toilet and sink in a Northeast Tacoma bathroom remodel, September 2026, before the floor and walls were closed.

What a Rough-In Covers

Six things are settled at this stage, and each is expensive to change after drywall.

Supply Lines

Where the hot and cold runs go and how they are sized, which sets the pressure and the wait for hot water at every fixture.

Drain, Waste and Vent

The slope on every drain and the vent that keeps each trap sealed. A drain without enough fall is a slow drain for the life of the house.

Fixture Positions

Stub-outs placed for the fixtures you have chosen, so the toilet, vanity and shower valve land where the design says they should.

Shower and Tub Valves

The valve body goes in at rough-in, at the height and depth the finished wall needs. We rough in customer-supplied valves as readily as our own.

Connections to the House

Tying a new bathroom or a new building into the existing stack, the main drain and the water service, which is often the hardest part of the job.

Testing and Inspection

The pipework is tested and presented to the inspector before anything closes over it.

Who We Rough In For

Bathroom and Kitchen Remodels

Moving a toilet, adding a sink or turning a tub into a walk-in shower all start with rough-in. Last September, at Wauna west of Gig Harbor, Efrain and Aiden took a bathroom back to the slab: they dug up the 4-inch and 3-inch drains outside the house, cored a new 4-inch opening through the wall for the new main with a cleanout outside, and roughed in the toilet, the sink and the homeowner’s own shower valve before the trench was tested and backfilled.

Additions and Basement Bathrooms

A new bathroom on a lower floor has to drain to a main that may run only a little lower than the new fixtures. We work out the route and the fall before framing goes up, and where gravity alone will not do it, we say so early.

ADUs and Backyard Cottages

Tacoma allows up to two accessory dwelling units on any legal lot, attached or detached, and a detached unit needs a water line and a building drain of its own run out to it. That usually means a new line from the meter sized for both buildings, a new building drain to the side sewer, and the rough-in inside. Our DADU job story follows one of these from the trench at the meter to the drains in the foundation.

New Homes

For a new house we rough in to the plans and the build schedule, and the same crew returns for trim-out, so nothing is handed between plumbers mid-build.

Rough-In Rules Around Pierce County

Permits Follow the Address

Inside Tacoma, plumbing permits and inspections come from the City of Tacoma. Lakewood, University Place, Puyallup, Gig Harbor and the other cities run their own, and unincorporated areas such as Parkland, Spanaway and the Gig Harbor peninsula outside the city are permitted by Pierce County. We file with the office that covers your address.

Inspection Before Anything Closes

The rough-in is inspected with the pipes still exposed. That is why we test the drains and supply lines ourselves first, and why we coordinate the date with the framing, electrical and insulation schedule.

Planning the Water Line for a Detached ADU

A detached ADU can share the main house’s water meter, as the West End cottage in our job story does, with a shutoff for each building where the line splits. Planning that early decides where the trench runs and whether the meter and the service line are large enough to carry both buildings.

Our Rough-In Process

1

Walk the Space and the Plans

We look at where the new fixtures go, where the existing stack, main drain and water service are, and what has to be opened to reach them.

2

Price and Permit

You see the price before any work starts, and we pull the permit with the city or Pierce County.

3

Install the Pipework

Supply, drain and vent run to the layout, properly supported, with valves and stub-outs set for the finished wall.

4

Test and Inspect

We test for leaks, present the work to the inspector and keep the schedule moving.

5

Return for Trim-Out

Once the walls and finishes are in, we come back to set the fixtures and turn everything on.

More On Planning a Build

Our guides on new-construction plumbing, layout planning and avoiding costly rework go further. Visit our blog.

Why Tacoma Homeowners Call Royal Flush

Veteran-Owned & Local

Family-operated out of Tacoma, serving Pierce and King County.

Upfront Pricing

You approve a clear price before any work starts. Estimates are free.

Licensed & Insured

Washington license #ROYALFP787R1, bonded and fully insured.

Fast Local Response

Urgent calls answered around the clock, from a crew based on Tacoma’s south side.

Flexible Payments Through Wisetack

Spread a larger repair over monthly payments, with no prepayment penalties and no hidden fees. VIP Home Protection members save 10% on every service.

Rough-In Plumbing Questions

Scope, scheduling, inspections and what happens when you are the one building.

Rough-in is the plumbing that goes in before the walls and floors close: the hot and cold supply lines, the drain, waste and vent piping, and the stub-outs each fixture will connect to. It is tested and inspected while it is still exposed, and the fixtures themselves are set later, at trim-out.

Small adjustments sometimes. Moving a drain is a bigger job, because its slope and vent have to be reworked, and changing it after drywall means opening walls. If a layout is still undecided, tell us before rough-in rather than after.

Don’t Gamble On Your Plumbing!

Veteran-owned, licensed and local. Call us or request service about a remodel, an addition or an ADU anywhere in Tacoma and the South Sound, and you will see the price before any work starts.

(253) 366-2904

Call NowRequest Service